National Service Hotline13805102923

Cutting machine

企业新闻
Where you are:

Tooth profile deviation of cutting machine

< Back to list
Source:未知Belongs to:News classificationTime:2017-02-15 12:41Attention:
Tooth profile deviation of cutting machine
     The tooth profile of involute gears reflects the change of shape. The actual tooth profile deviates from the design of the tooth profile, which is called the tooth profile deviation
In-plane and perpendicular to the involute profile (see Figure 9-6). Design tooth profile is to meet the design requirements of the tooth profile, when no
Special requirements refer to the end face profile. The profile curve includes the actual tooth profile, the design of the tooth profile and the average tooth profile.
     The working part of the profile is usually the theoretical line. In the modern gear design, for high-speed gear transmission, in order to reduce the base circle
Pitch and deviation of the gears caused by the impact of elastic, vibration and noise, often using the theory of involute tooth profile based on the correction teeth
Profile, such as the repair of the toothed, convex and so on, therefore, the design of tooth profile can be ashamed open line tooth profile or repair tooth layer.